Page 1 of 1

Question about unexpected behaviour in Design Mode

PostPosted: Mon Oct 08, 2018 3:10 pm
by ANH

we've encountered a problem with the design mode of the VisionX wizard.
There we had the problem that controls were not associated correctly to their columns though the column names were set correctly, but was suplied by a function calls. We tested a bit and came to this case:

Code: Select all
    UIEditor editDocId = new UIEditor();       
    // ...
    // ...
    String colName = "this_is_not_a_column_name";

The Control 'editId' shows nothing while the applications runs in normal mode, because "this_is_not_a_column_name" is not a valid column name of the databook 'rdb'.

In design mode the control 'editId' was bound to the column of the databook named "id_column_name".

About this I have two questions:

1) What are save ways to suply the name of a column as an argument for setColumnName?

2) Is it correct, that in design mode our code is actually not exectuted as usual?
2a) ...and therefore no logging works at all?

Thank you!

Best Regards

Re: Question about unexpected behaviour in Design Mode

PostPosted: Tue Oct 09, 2018 3:47 pm
by Support@SIB
This question is related to the commercial product VisionX.
Please contact the product support!